Satrap OECOPLAN 50 GS A+ User Manual download pdf (Page 43)

Placement

The ambient temperature has an effect on the energy

consumption and proper operation of the appliance.

When placing, take into consideration that it is

practical to operate the appliance between ambient

temperature limits according to the climate class that

is given in the chart below and can be found in the

data label.

If the ambient temperature goes below the lower data

the temperature of the cooling compartment can go

beyond the prescribed temperature.

Class of climate

Ambient temperature

+10 ... +32 °C

+16 ... +32 °C

+18 ... + 38 °C

If the ambient temperature goes beyond the upper

data this means longer operating time of the

compressor, increasing temperature in the cooling

compartment or increasing energy consumption.

When placing the appliance ensure that it stands level.

Mount the spacers supplied in the plastic bag of

the accessories. Hold the spacer as shown on the

Fig., using fine strokes of hammer put it in its

place.

Do not stand the appliance on a sunny place or close

to a radiator or cooker.

If it is unavoidable because of furnishing and the

appliance has to be stood near a cooker take these

minimum distances into consideration:

In case of gas or electric cooker 3 cm must be left,

when it is less put a 0,5-1 cm non-flam insulation

between the two appliances.

In case of oil or coal-fired stove the distance must

be 30 cms since they give off more heat.

The refrigerator is designed to operate when it is

totally pushed to the wall.

When placing the refrigerator keep minimal

distances recommended in figure.

A : placing it under a wall-cupboard

B : placing it freely

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 51 52

No comments

Satrap OECOPLAN 50 GS A+ User Manual Page 43